HYOSUNG TE 450 Service Manual page 76

◉ ◉ STARTER CLUTCH
Install the starter driven gear onto the starter clutch
and turn the starter driven gear by hand(the gear
turns in only one direction). The starter driven gear
should turn smoothly. If excessive resistance is felt
while turning the starter driven gear, inspect the
starter clutch. Also, inspect the surface of the starter
driven gear which contacts the starter clutch, for
wear or damage. If any wear or damage is found,
replace the defective parts.
▣ ▣ DISASSEMBLY
● With the magneto rotor held immovable, remove
the starter clutch bolts.
▣ ▣ REASSEMBLY
● Apply a small quantity of THREAD LOCK "1324"
to the starter clutch bolts and tighten them to the
specified torque with the magneto rotor held
immovable.
THREAD LOCK "1324"
Starter clutch bolt
: 23~28 N∙ ∙ m (2.3~2.8 kgf∙ ∙ m)
ENGINE 3-34