● Remove the reverse lever ① .
● Disconnect the cable by removing the spool ② .
● Remove the engine sprocket cover.
(Refer to page 3-3)
● Disconnect the reverse cable by removing the
cable mounting screw.
▣ ▣ REMOUNTING
Remount the reverse cable in the reverse order
removal.
Pay attention to the following points :
● Install the spring with the spring end ③
the groove ④
on the housing.
● Apply SUPER GREASE "A" to the O-ring ⑤ .
SUPER GREASE "A"
● Install the O-ring ⑤
● Connect the cable to the spool ⑦
of the housing.
matched
to the reverse cable ⑥ .
through the hole
CHASSIS 7-52
①
③
⑥
⑤
②
④
③ ⑦