◉ ◉ REASSEMBLY AND REMOUNTING
Reassemble and remount the steering shaft in the
reverse order of removal and disassembly.
Pay attention to the following points :
▣ ▣ STEERING SHAFT
● Apply SUPER GREASE "A" to the O-ring, dust
seals and steering shaft before remounting the
steering shaft.
SUPER GREASE "A"
● Install the dust seal ①
steering shaft.
● Install the new O-ring ③
steering shaft.
● Tighten the steering shaft nut to the specified
torque.
Steering shaft nut
● Install the cotter pin.
CAUTION
Replace the removed cotter pin with a new one.
● Apply SUPER GREASE "A" to the dust seals ⑤
and sliding surface of the steering shaft holders
before remounting the steering shaft holders.
SUPER GREASE "A"
and bushing ②
to the
and washer ④
to the
: 49 N∙ ∙ m (4.9 kgf∙ ∙ m)
CHASSIS 7-36
①
②
③
④
③
⑤