HYOSUNG TE 450 Service Manual page 170

7-17 CHASSIS
◉ ◉ BRAKE CALIPER REASSEM-
BLY AND REMOUNTING
Reassemble and remount the brake caliper in the
reverse order of removal and disassembly proce-
dures and observe the following points.
CAUTION
� � Wash the brake caliper components with fresh
brake fluid before reassembly. Do not wipe off
brake fluid with a rag after washing the compo-
nents.
� � Replace the piston seal and dust seal into new
ones with brake fluid applied.
Brake fluid specification and classification
● Install the brake pad spring.
● Apply SILICONE GREASE to the brake caliper
holder pin.
SILICONE GREASE
● Install the brake pads. (Refer to page 7-14)
● Tighten the brake pad mounting pins ① , brake
caliper mounting bolts ②
bolts ③
to the specified torque.
Front brake pad mounting pin
: 18~28 N∙ ∙ m (1.8~2.8 kgf∙ ∙ m)
Front brake caliper mounting bolt
: 18~28 N∙ ∙ m (1.8~2.8 kgf∙ ∙ m)
Front brake hose union bolt
: 40~60 N∙ ∙ m (4.0~6.0 kgf∙ ∙ m)
NOTE
Before remounting the brake caliper, push the
brake caliper pistons all way into the caliper.
● Fill the system with brake fluid and bleed air.
(Refer to page 2-17)
Inspection after reassembly : Refer to page 2-16
: DOT 4
and brake hose union
②
③
①