HYOSUNG TE 450 Service Manual page 196

7-43 CHASSIS
● Tighten the caliper mounting bolts to the specified
torque.
Brake caliper mounting bolt
: 18~28 N∙ ∙ m (1.8~2.8 kgf∙ ∙ m)
● Adjust the parking brake. (Refer to page 2-15)
◉ ◉ BRAKE FLUID REPLACEMENT
● Place the vehicle on a level surface.
● Remove the master cylinder reservoir cap ①
diaphragm.
● Suck up the old brake fluid as much as possible.
● Fill the reservoir with new brake fluid.
Specification and classification : DOT 4
● Connect a clear hose to the air bleeder valve and
insert the other end of the hose into a receptacle.
● Loosen the air bleeder valve and pump the brake
pedal until the old brake fluid is completely out of
the brake system.
● Close the air bleeder valve and disconnect the
clear hose.
Fill the reservoir with new brake fluid to the upper
level.
Brake air bleeder valve
: 9~14 N∙ ∙ m (0.9~1.4 kgf∙ ∙ m)
CAUTION
� � Never reuse the brake fluid left over from previ-
ous servicing and stored for long periods.
� � Bleed air from the brake system.
(Refer to page 2-17)
and
①