Table of Contents
Advertisement
Fins bent down or dented can be repaired by
straightening them with the blade of a small screw-
driver.
◉ ◉ INSPECTION OF WATER HOSE
● Remove the front fender. (Refer to page 7-3)
Any water hose found in a cracked condition or flat-
tened or water leaked must be replaced.
Any leakage from the connecting section should be
corrected by proper tightening.
◉ ◉ REMOUNTING
The radiator reassembly can be performed in the
reverse order of disassembly procedures.
However, the following points must be observed in
the reassembly operation.
● Install the radiator with the specified torque.
Radiator mounting bolt
: 8~12 N∙ ∙ m (0.8~1.2 kgf∙ ∙ m)
�Pour engine coolant
�Bleed air from the cooling circuit
◉ ◉ RADIATOR RESERVOIR TANK
▣ ▣ REMOVAL / REMOUNTING
● Remove the reservoir tank mounting bolts and dis-
connect the siphon hose from the reservoir tank
and drain engine coolant.
● Install the reservoir tank in the reverse order of
removal.
● Fill the reservoir tank to the upper level line.
Refer to page 2-12
∙∙∙∙∙
Refer to page 2-12
∙∙
COOLING SYSTEM 5-4
Hide quick links:
Advertisement
Table of Contents
