◉ ◉ MASTER CYLINDER REASSEM-
BLY AND REMOUNTING
☞ Refer to page 7-20
Reassemble and remount the master cylinder in the
reverse order of removal and disassembly.
Pay attention to the following point :
● Apply MOLY PASTE to the master cylinder push
rod.
MOLY PASTE
● Install the master cylinder rod lock nut ① , adjuster
②
and rear master cylinder pin ③ .
● Tighten the master cylinder rod lock nut ① , mas-
ter cylinder mounting bolts ④
union bolt ⑤
to the specified torque.
Rear brake master cylinder rod lock nut ① ①
: 10~20 N∙ ∙ m (1.0~2.0 kgf∙ ∙ m)
Rear brake master cylinder mounting
bolt ④ ④
: 8~12 N∙ ∙ m (0.8~1.2 kgf∙ ∙ m)
Brake hose union bolt ⑤ ⑤
: 40~60 N∙ ∙ m (4.0~6.0 kgf∙ ∙ m)
CAUTION
� � The removed brake hose washers should be
replaced with new ones.
� � Bleed air from the system after reassembling
the brake master cylinder. (Refer to page 2-17)
and brake hose
①
②
③
⑤
CHASSIS 7-50
④