Table of Contents
Advertisement
22
Chapter 3 Hardware installation
Figure 6 Slide in the WFC
4
Press the WFC firmly at the top-left corner, center, and right tabs.
The WFC snaps into place.
5
Optional: Install the three screws to secure the WFC in place.
Desktop-mount installation
Follow this procedure to install a BCM unit (main unit or expansion unit) on a desktop or other flat
surface.
To install a BCM50 unit on a desktop or flat surface
1
Insert the power-supply retention clip into the BCM50 unit.
2
Attach the four self-adhesive rubber feet to the bottom of the BCM50 unit by peeling off the
paper backing and placing the feet on the unit.
3
Position the BCM50 unit on a table or shelf. Make sure you leave enough space around the
unit for ventilation and access to the cables.
4
If the BCM50 system requires additional units, install the other units on top of, or beside, the
existing BCM50 unit.
•
To install the additional units beside the existing unit, repeat steps 1 to 3 for each unit.
•
To install the additional units on top of the existing unit, refer to
on top of another unit
5
Install the power supply using a method appropriate for your installation. For details about
installation options, see
Installing the BCM50 power supply
There are several different ways to install a power supply. Select the method that works best for
your type of installation. The power supply must be within 1.5 m (5 feet) of the BCM50 unit and
within 1.5 m (5 feet) of the AC power outlet (wall outlet or UPS).
NN40020-308
on page 19.
Installing the BCM50 power supply
4 minutes
To install a BCM50 unit
on page 22.
Advertisement
Table of Contents
