Mitsubishi MELSEC-Q Series User Manual page 33

2
SYSTEM CONFIGURATION
(b) Mounting to a MELSECNET/H remote I/O station
Applicable network module
QJ72LP25-25
QJ72LP25G
QJ72LP25GE
QJ72BR15
Remark
(2) Support of the multiple CPU system
When using the QD72P3C3 in a multiple CPU system, refer to the following manual
first.
(a) Intelligent function module parameters
* 1 Limited within the range of I/O points for the CPU module.
* 2 Can be installed to any I/O slot of a base unit.
* 3 For the coincidence detection interrupt function, use the Basic model QCPU module of function
version B or later.
* 4 The dedicated instructions are not supported.
* 5 The coincidence detection interrupt function is not supported.
The table below shows the network modules and base units applicable to the
QD72P3C3 and quantities for each network module model.
Depending on the combination with other modules or the number of mounted
modules, power supply capacity may be insufficient.
Pay attention to the power supply capacity before mounting modules, and if the
power supply capacity is insufficient, change the combination of the modules.
*3*4
No. of modules
Up to 64
* 1 Limited within the range of I/O points for the network module.
* 2 Can be installed to any I/O slot of a base unit.
* 3 The coincidence detection interrupt function is not supported.
* 4 The dedicated instructions are not supported.
The Basic model QCPU or C Controller module cannot create the MELSECNET/
H remote I/O network.
• QCPU User's Manual (Multiple CPU System)
Write intelligent function module parameters to only the control CPU of the
QD72P3C3.
Base unit
*1
Main base unit of
remote I/O station
: Applicable
2.3 Applicable Systems
1
2
3
*2
Extension base
unit of remote I/O
station
4
: N/A
5
6
7
8
2
- 4