Mitsubishi MELSEC-Q Series User Manual page 101

5
PROCEDURES AND SETTINGS BEFORE
OPERATION
(2) Checking using GX Configurator-PT
Monitor the external I/O signal status on the [Monitor/Test] screen.
(For details, refer to "Section 6.6 Monitoring/Test".)
(Example) Checking the external I/O signals of Axis 1 (Axis #1 OPR Monitor)
(GX Configurator-PT screen)
IMPORTANT
If the QD72P3C3 has a failure or does not recognize necessary signals, such as
the near-point dog signal and upper/lower limit signals, an unexpected accident,
e.g. "the axis collides with the stopper without decelerating at the near-point dog
during machine OPR control", may occur.
Be sure to perform "connection check" not only when the positioning control
system is configured but also when any modification, such as module change or
rewiring, has been made.
5.5 Wiring Check
5.5.1 Check items at wiring completion
1
2
3
4
5
6
7
8
5
- 13