Mitsubishi MELSEC-Q Series User Manual page 190

9
POSITIONING CONTROL
The following table shows a setting example when "current value change" is set in
positioning data of axis 1.
Setting item
Da.1
Axis 1 Da.2
positioning
Da.3
data
Da.4
Da.5
movement amount
9
- 14 9.2 Positioning Data Setting
9.2.4 Current value change
Positioning data setting example
Operation pattern
Current value change Set the current value change.
Control method
ACC/DEC time
Command speed
Positioning address/
* For details of setting, refer to "Section 4.4 Positioning Data List".
Setting example
Set positioning start (independent) assuming
Positioning start
position control whose movement amount is
(independent)
within 268435455pulses is performed.
- Setting not required (Setting value is ignored).
- Setting not required (Setting value is ignored).
10000pulse Set the destination address.
Setting contents