8.5
Activating function modules
Subfunctions can be activated in the SINAMICS family drives as function modules.
Through activation, the parameters of the corresponding functionalities are also displayed.
Function modules can be individually activated / deactivated on every drive object.
For SINAMICS DC MASTER, the following subfunctions are modeled as function module.
● Technology controller
● Free function blocks
● PROFINET interface
8.5.1
Activating offline with STARTER
Function modules can be defined for all DOs by using the properties dialog (activate by
clicking with the right mouse button on the DO in the project navigator). Shown as example
for the closed-loop control DO "Drive_1":
Figure 8-33
Properties
SINAMICS DCM DC Converter
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
Commissioning
8.5 Activating function modules
263