Activating Function Modules - Siemens SINAMICS Series Operating Instructions Manual

8.6

Activating function modules

Subfunctions can be activated in the SINAMICS family drives as function modules.
Through activation, the parameters of the corresponding functionalities are also displayed.
Function modules can be individually activated / deactivated on every drive object.
For SINAMICS DC MASTER, the following subfunctions are modeled as function module.
● Technology controller
● Free function blocks
● PROFINET interface
8.6.1 Activating offline with STARTER
Function modules can be set for all DOs by using the properties dialog (activate by right-
clicking the DO in the project navigator). Example shown for the closed-loop control DO
"Drive_1":
Figure 8-34 Properties
SINAMICS DCM DC Converter
Operating Instructions, 12/2018, A5E34763375A
Commissioning
8.6 Activating function modules
321