Siemens SINAMICS DCM Operating Instructions Manual page 550

Index
Control via PROFIBUS, 341
Control word, 344
Control word for encoder, 414
Converter Commutation Protector, 29
Copying RAM to ROM, 260
CPU time load, 496
Creep, 408
CUD
LEDs, 485
D
Data sets
Command data set (CDS), 288
Drive data set (DDS), 289
Encoder data set (EDS), 290
DCC, 501
DDS, 289
Device dimensions, 72
Diagnostics
Diagnostic memory, 483
Trend recorder function, 483
using LEDs for CBE20, 173
using LEDs for the Sensor Module Cabinet
SMC30, 184
using LEDs on Terminal Module TM15, 198
using LEDs on Terminal Module TM31, 215
Digital inputs, 158
Digital outputs, 158
Dimension drawings, 72
Dimensions, 72
Disconnection, 397
Disposal, 536
Drive Control Chart, 501
Drive object, 292
Drive optimization, 273
Optimization runs, 274
DRIVE-CLiQ, 164
Duty cycles, 37
Dynamic overload capability of the power unit, 440
E
EDS, 290
Electromagnetic compatibility, 85
Electronics power supply, 106, 155, 156
EMC, 85
Basic information, 85
Cabinet configuration, 92
EMC-compliant installation, 89
EN 61800-3, 86
548
RFI suppression filter, 94, 97
Shielding, 94
Enable, 400
Encoder
Control word, 414
Incremental encoder evaluation, 159, 160
Status word, 416
Encoder evaluation, 410
Environmental classes, 40
Environmental compatibility, 536
E-STOP, 401
F
Factory setting, 236
Fan
Operating hours counter, 431
Replacing the fan, 514
Terminals, 156
Fault buffer, 490
Fault value, 490
Faults, 488
Acknowledging, 489
Configuring, 492
Fault buffer, 490
Faults and alarms, 488
BICO interconnections, 495
Faults and alarms, 488
Field characteristic, 276
Field reversal, 470
Field supply, 133
Fixed setpoint, 409
Friction characteristic, 277
Function modules
Technology controller, 424
Fuses, 137
Replacing fuses, 519
H
Holding brake, 427
Hot restart time, 447
I
I2t monitoring, 432
Incremental encoder evaluation, 159, 160, 176, 410
Inputs, 158
Analog, 158
Digital, 158
Overview, 337
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
SINAMICS DCM DC Converter