Remove (With Starter) - Siemens SINAMICS DCM Operating Instructions Manual

Dc converter

Hide thumbs Also See for SINAMICS DCM:

Table of Contents

Commissioning

8.6 Commissioning optional additional modules

● Use the "Encoder data" button to enter the data of this encoder.

● If you also want to use the encoder connected to the SMC30 as the actual value for the

● Run through the wizard until the end and load the expanded project into the drive.

Remove (with STARTER)

Note: It is only possible to remove the encoder evaluation from the project in the offline mode

● Start the drive wizard via Configuration - configure DDS

● With Continue>, go to the "Encoder" screen form, and there, deselect encoder 2

● Run through the wizard until the end

● Unplug the encoder evaluation SMC30

● Load the project to the drive

2. Activating the encoder

speed controller, you have to select as the source for the actual value "5: encoder on

Operating Instructions, 1.2012, C98130-A7066-A1-05-7619

SINAMICS DCM DC Converter