Siemens SINAMICS DCM Operating Instructions Manual page 326

Operation
9.3 Controlling via the AOP30 operator panel
TM31 object
Table 9- 11 List of signals for the operation screen – TM31 object
Signal
Analog input 0 [V, mA]
Analog input 1 [V, mA]
Analog input 0, scaled
Analog input 1, scaled
Setting the date/time
Settings: MENU – Commissioning/Service – AOP settings
For date stamping in the case of fault codes and alarms, and for AOP time display on the
operation screen
The AOP30 contains a battery-buffered real-time clock.
You set the date and time on this screen.
Synchronization
You can also set whether and/or how the AOP30 and drive unit are to be synchronized.
Synchronizing the AOP with the drive enables fault codes and alarms to be date- stamped
and time-stamped (in the default setting, time-stamping occurs in accordance with the CU
runtime).
● None (factory setting)
● AOP → Drive
● Drive → AOP
324
Parameter
r4052[0]
r4052[1]
r4055[0]
r4055[1]
The AOP30 and drive unit times are not synchronized.
– Activating this option synchronizes the AOP and drive unit immediately, whereby the
current AOP time is transferred to the drive unit.
– The current AOP30 time is transferred to the drive unit every time the AOP30 is
started.
– At 02:00 (AOP time) every day, the current AOP30 time is transferred to the drive unit.
– If a time-of-day master is connected to the drive, then activating this option enables
the AOP and drive unit to be synchronized immediately, whereby the current drive unit
time is transferred to the AOP30.
– The current drive unit time is transferred to the AOP30 every time the AOP30 is
restarted.
– At 02:00 (AOP time) every day, the current drive unit time is transferred to the AOP30.
Short name Unit
AI_UI V, mA
AI_UI V, mA
AI_% %
AI_% %
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
Scaling (100% = ...)
V: 100 V / mA: 100 mA
V: 100 V / mA: 100 mA
V: 100 V / mA: 100 mA
V: 100 V / mA: 100 mA
SINAMICS DCM DC Converter