Data Sets - Siemens SINAMICS DCM Operating Instructions Manual

Operation
9.1 Basic information
Note
Data on the memory card are not deleted by setting p0976=200. In spite of this, when
deleting all user data, it is not permissible that a memory card is inserted. An inserted
memory card would mean that for an automatic power-up after p0976=200, as usual, the
data would be read from the memory card (see also Chapter "Memory card functions"). The
unit would power-up with the parameter assignment from the memory card.
Access level
The parameters are subdivided into access levels. The SINAMICS DCM List Manual
specifies the access level at which the parameter can be displayed and modified. The
required access levels 0 to 4 can be set in p0003.
Table 9- 1
0 User-defined
1 Standard
2 Extended
3 Expert
4 Service
9.1.2

Data sets

CDS: Command data set
The BICO parameters (binector and connector inputs) are grouped together in a command
data set. These parameters are used to interconnect the signal sources of a drive.
By parameterizing several command data sets and switching between them, the drive can
be operated with different pre-configured signal sources.
A command data set contains the following (examples):
● Binector inputs for control commands (digital signals)
● Connector inputs for setpoints (analog signals)
288
Access levels
Access level
Parameter from the user-defined list (p0013)
Parameters for the simplest possible operations (e.g. p50303 = ramp-
function generator ramp-up time)
Parameters for handling the basic functions of the unit
Expert knowledge is already required for these parameters (e.g. knowledge
of assigning BICO parameters).
Please contact your local Siemens office for the password for parameters
with access level 4 (Service). It must be entered into p3950.
– ON/OFF, enable signals (p0844, etc.)
– Jog (p1055, etc.)
– Speed setpoint (p50433)
– Torque setpoints (p50500, p50501)
Comment
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
SINAMICS DCM DC Converter