Siemens SINAMICS DCM Operating Instructions Manual page 321

Dc converter

Hide thumbs Also See for SINAMICS DCM:

Table of Contents

The data set selection dialog appears whenever a data set parameter is changed in the

parameter list. The data set selected in the data set selection screen is a default setting.

● Permanent parameter transfer

Parameter changes in the SINAMICS DC MASTER are only made temporarily in the RAM. If

a parameter assignment is intended to be permanent, it is possible to trigger a save process

at this point. Depending on the configuration, this can take from 45 s to several minutes.

Also refer to the "Operation" chapter, "Memory Card functions" section.

SINAMICS DCM DC Converter

Operating Instructions, 1.2012, C98130-A7066-A1-05-7619

9.3 Controlling via the AOP30 operator panel