Connecting
6.2 Cable routing into the unit
①
②
③
④
Figure 6-11
102
Connection for the electronics power supply (XP1). Mechanically attach the cable using one of
⑤
the shield clamps
at the side of the enclosure. 2 holes on the printed-circuit board to attach
the cable using cable ties.
Connection for the analog tachometer (XT1) Connect the shield to one of the shield clamps
on the side of the enclosure.
Connection for E-STOP (XS1). Route the cable into the unit from the bottom.
Connection for the floating relay output for the line contactor (XR1). Route the cable into the
unit from the bottom.
Cable routing, power interface
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
⑤
SINAMICS DCM DC Converter