Siemens SINAMICS DCM Operating Instructions Manual page 327

Date format
The date format can be set in this menu:
● DD.MM.YYYY: European date format
● MM/DD/YYYY: North American date format
RS485 bus termination active
Settings are not effective: The RS485 bus termination is continuously active.
DO name display mode
A user-definable DO name can be activated/deactivated on this screen.
In the drive, there is the option of entering a user-defined, 25-character DO name for each
DO, using the configuration software.
The possible number of characters in a DC name display is limited by the screen in question:
1. DO name in screens displaying the current DO
2. DO names in the overview of faults and alarms (alarm overview)
Texts that have been shortened can be displayed in full for around 3 seconds by pressing
the "+/-" button, provided that the "User-definable DO name" function is activated.
Reset AOP settings
Selecting this menu command resets the AOP factory settings for the following:
● Language
● Display (brightness, contrast)
● Operating screen
● Control settings
SINAMICS DCM DC Converter
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
Examples of screens in this category are operation screens, parameter lists, quick
commissioning wizard screens, etc.
The maximum text length is 7 characters. Example {2:DC_CTRL}
Texts of up to 7 characters in length are displayed in full. The first six characters of texts
that are 8 to 25 characters in length are displayed with "..." as the seventh character.
The maximum text length is 12 characters. Example 2:HOIST 12345
Texts of up to 12 characters in length are displayed in full.
The first 11 characters of texts that are 13 to 25 characters in length are displayed with
"..." as the 12th character.
NOTICE
When you reset parameters, all settings that are different from the factory settings are
immediately reset on the operator panel. This may cause the unit to switch to an
unwanted operating state. For this reason, you should always take great care when
resetting parameters.
9.3 Controlling via the AOP30 operator panel
Operation
325