Siemens SINAMICS DCM Operating Instructions Manual page 229

〈5.3〉Operation without tachometer (closed-loop EMF control)
p50083[D] = 3 The actual speed value comes from the "Actual EMF value" channel
p50115[D]
p2000
〈5.4〉Freely-wired actual value
p50083[D] = 4 The actual-value input is defined with p50609[C]
p50609[C]
p2000
SINAMICS DCM DC Converter
Operating Instructions, 1.2012, C98130-A7066-A1-05-7619
(r52287),
but is evaluated with p50115.
EMF at 100% speed
(1.00 to 140.00% of unit rated supply voltage (p50078[0]))
Remark:
The value set here determines the 100% speed for the closed-loop speed
control.
Speed in rpm for EMF set on p50115[0]
Comment 1:
Parameter p2000 is used to convert from a "physical speed" (rpm) into a
"relative speed" (%) and vice versa.
This conversion is required for:
 Speed setpoint input via the control panel in STARTER
 Speed setpoint input via the operating screen form at the AOP30
 Calculating the display values r020, r021, r060 and r063
Remark 2:
Parameter p2000 and parameters r020, r021, r060 and r063 are not data-set
dependent. This is the reason that the physical speed can only be displayed
correctly for one data set (DDS).
Number of the parameter that is switched to the actual speed controller
value
Speed in rpm at which the parameter selected on p50609[0] accepts the
value 100%
Comment 1:
Parameter p2000 is used to convert from a "physical speed" (rpm) into a
"relative speed" (%) and vice versa.
This conversion is required for:
 Speed setpoint input via the control panel in STARTER
 Speed setpoint input via the operating screen form at the AOP30
 Calculating the display values r020, r021, r060 and r063
Remark 2:
Parameter p2000 and parameters r020, r021, r060 and r063 are not data-set
dependent. For that reason, the physical speed can only be displayed
correctly for one data set (CDS).
8.2 Commissioning using the BOP20 operator panel
Commissioning
227