Activating Function Modules; Activating Offline Via Starter - Siemens sinamics dcp Operating Instructions Manual

Commissioning

7.4 Activating function modules

7.4 Activating function modules
Subfunctions can be activated in the SINAMICS family drives as function modules.
Through activation, the parameters of the corresponding functionalities are also displayed.
Function modules can be individually activated/deactivated on every drive object.
For SINAMICS DCP, the following subfunctions are modeled as function modules.
● Free function blocks
● PROFINET interface
7.4.1

Activating offline via STARTER

Function modules can be defined for all DOs by using the properties dialog (activate by right-
clicking the DO in the project navigator). Shown as an example for the closed-loop control
DO "Drive_1":
Image 7-25 Properties
The function modules can be accessed in the "Function modules" tab in the opening dialog.
102
Operating Instructions, 05/2016, A5E34382853K
SINAMICS DCP