Library Conversions; Desktop To Rack Mounted Library Conversion - IBM System Storage TS3310 Setup And Operator Manual

4. Connect the power supply by plugging in each end of the power cord in the
5. Toggle the power switch (
6. Power ON the library using the power button on the front of the machine.
Removing a Redundant Power Supply
1. Locate the slot for the redundant power supply to be removed on the back of
2. Toggle the redundant power supply power switch (
3. Unplug the power cord from the redundant power supply receptacle (
4. Loosen the two thumb screws (
5. Grasp the handle (
6. Install a metal cover plate over the vacant redundant power supply slot if you
Replacing a Redundant Power Supply
1. Locate the slot for the redundant power supply on the back of the library
2. Remove the cover plate over the vacant redundant power supply slot, if
3. Insert the redundant power supply by gripping the handle (
4. Tighten the two thumb screws (
5. Connect the power cord to the power supply (
6. Turn on power to the redundant power supply, using the switch (

Library Conversions

Refer to the following sections for library conversion instructions:
v "Desktop to Rack Mounted Library Conversion"
v "Rack Mounted to Desktop Library Conversion" on page 12-27

Desktop to Rack Mounted Library Conversion

Complete the following to convert your library from a desktop unit to a rack
mounted unit.
1. Perform "Preparing a Library or Library Module for Repairs" on page 12-2.
12-26
TS3310 Tape Library Setup and Operator Guide
proper sequence.
Attention: First, connect the power cord to the power supply component (
in Figure 12-20 on page 12-25). Then, connect the power cord to the power
source.
supply to the | (ON) position.
the library.
12-25) to the O (OFF) position.
Figure 12-20 on page 12-25).
them counterclockwise.
1
in Figure 12-20 on page 12-25) and pull the power
supply toward you. Support the component from underneath with your other
hand.
are not immediately installing a replacement.
module.
necessary.
on page 12-25), sliding it into the guide slots, and pushing it into the empty
slot.
redundant power supply in place.
12-25) and to its source.
Figure 12-20 on page 12-25) on the power supply.
4
in Figure 12-20 on page 12-25) on the power
2
in Figure 12-20 on page 12-25) by turning
2
in Figure 12-20 on page 12-25) that hold the
3
4
in Figure 12-20 on page
3
1
in Figure 12-20
in Figure 12-20 on page
4
in
3
in