Removing The Compact Flash Card From - IBM System Storage TS3310 Setup And Operator Manual

Figure 12-18. Removing the Compact Flash Card from the Library Control Blade
1. Ensure the library power is OFF. See "Preparing a Library or Library Module
2. Remove the Library Control Blade (LCB). See "Removing the Library Control
3. Locate the compact flash card component on the LCB board (
4. Without touching any other components on the LCB firmware board, carefully
5. Carefully lift the compact flash card out of the LCB board and place it on a
12-22
TS3310 Tape Library Setup and Operator Guide
You will need this information to re-configure your library after
replacing the card. Use the Operator Panel to re-configure your library.
for Repairs" on page 12-2.
Blade (LCB)" on page 12-18) for detailed instructions.
Figure 12-18).
grasp the compact flash card and wiggle it using a gentle, side-to-side motion (
2
in Figure 12-18) until the pins on the compact flash card become
disconnected from the pins on the LCB board (
slowly slide the compact flash card out of the guide slots.
clean, flat surface.
1
3
2
4
1
in
3
in Figure 12-18). Then,