Replacing A Drive Sled; Control Module; Guide Rails And Guide Slots Inside A Drive - IBM System Storage TS3310 Setup And Operator Manual

Replacing a Drive Sled

Attention: NEVER install a drive sled when a cartridge is in the drive in the eject
position. Remove the cartridge first.
Figure 3-28. Control Module Drive Sled
1. Align the drive sled with the guide rails and guide slots along the tracks ( 3
Figure 3-29. Guide rails and guide slots inside a drive slot
2. Grasp the handle ( 5 in Figure 3-30 on page 3-31) and slowly slide the drive
3-30
TS3310 Tape Library Setup and Operator Guide
in Figure 3-29).
3
sled into the drive slot, while supporting the drive sled from underneath.
2
1
1