Cabling Of A 14U Library Containing - IBM System Storage TS3310 Setup And Operator Manual

3
2
Figure 3-33. Cabling of a 14U library containing multiple SCSI drives
1. Install a module communication terminator in the upper receptacle of the
2. Install one end of the module-to-module communication cable ( 2 in
3. Install a module communication terminator in the lower receptacle of the lower
4. Install one end of the customer-supplied Ethernet cable ( 3 in Figure 3-33) in
5. Installation of the SCSI cable(s) and terminator(s) depends upon how many
3-34
TS3310 Tape Library Setup and Operator Guide
4
1
1
Module communication
terminator
2
Module-to-module
communication cable
3
Ethernet cable (customer
supplied)
4
Module communication
terminator
5
SCSI terminators
upper module of your library ( 4 in Figure 3-33).
Figure 3-33) in the lower receptacle of the upper module of your library, then
install the other end in the upper receptacle of the lower module of your
library.
module of your library ( 1 in Figure 3-33).
the Library Control Blade Ethernet port, then connect the other end of the cable
to your network.
drives are in your library. For maximum SCSI drive performance:
v For each SCSI drive, install a SCSI terminator ( 5 in Figure 3-33) in the
upper receptacle of each SCSI drive in your library.
5
9
6
SCSI drive-to-host cable
7
Power cord (upper module)
8
Power cord (lower module)
9
SCSI drive-to-host cable
7
6
8