Enabling The Picker Assembly; Installing The Rack Ears On A Control - IBM System Storage TS3310 Setup And Operator Manual

2
Figure 3-26. Installing the rack ears on a control module
2. Install the left rack ear ( 3 in Figure 3-26 and 6 in Figure 3-12 on page 3-13).
3. Close the I/O Station and Access doors.
4. Repeat this procedure for all modules in the library.

Enabling the Picker Assembly

Important: Picker assembly damage or library accessor errors can occur if the front
3-28
TS3310 Tape Library Setup and Operator Guide
a. At the bottom right of the I/O Station position on each library module,
there is a slot ( 2 in Figure 3-26). Insert the right rack ear ( 1 in
Figure 3-26 and 7 in Figure 3-12 on page 3-13) into the slot.
b. Position the right rack ear flush with the rack. The slots in the rack ear
should be positioned as follows:
v In the bottom library module, over the holes in the rack that align with
the holes in the rack kit rails.
v In the middle or top library module, over the holes in the rack that have
clip/cage nuts installed.
c. Place the screws ( 8 in Figure 3-12 on page 3-13) in the slots on the right
rack ear and tighten.
a. Open the left door of the library module slightly.
b. Grasp the hinged side of the door and, while pulling on the door, push to
the right to expose the slot ( 4 in Figure 3-26) for the left rack ear .
c. Insert the left rack ear ( 3 in Figure 3-26) into the slot.
d. Position the left rack ear flush with the rack. The slots in the rack ear
should be positioned as follows:
v In the bottom library module, over the holes in the rack that align with
the threaded holes in the rack kit rails
v In the middle or top library module, over the holes in the rack that have
clip/cage nuts installed
e. Place the screws ( 8 in Figure 3-12 on page 3-13) in the slots on the left
rack ear and tighten.
or rear gear racks are not engaged properly.
3 4