Figure 3-24. Sling
10. Adjust the upper module's position on top of the lower module until the
11. Tighten the front thumb screw ( 2 in Figure 3-23 on page 3-25) and the
12. Tighten the rear thumb screws ( 1 in Figure 3-25 on page 3-27) that secure
3-26
TS3310 Tape Library Setup and Operator Guide
5. Slide the module partially on top of the already installed module(s).
6. Continue to support the library module from the front while you remove the
sling.
7. Open the I/O Station door then the Access Door of the upper module to
expose the alignment pin behind the Access Door.
8. Push the upper module onto the lower module.
9. Twist the upper module alignment pin ( 1 in Figure 3-23 on page 3-25) to
unlock it from the up position.
upper module alignment pin drops into the alignment pin receptacle in the
lower module.
thumb screw behind the I/O Station door to secure the front of the upper
module to the lower module.
the upper module to the lower module.