Applying A License Key; Cleaning Slots Configuration - IBM System Storage TS3310 Setup And Operator Manual

Note: Make sure that the library is connected to the network before modifying
To modify network settings, you need to provide the data for the following fields:
v Library Name is the network name you want to assign to the library. The library
v Dynamic Host Configuration Protocol (DHCP) setting defaults to enabled.
v IP Address is the IP Address of the library. This text box is available only if
v Default Gateway is the IP Address of the default gateway for your portion of
v Subnet Mask text box is available only if DHCP is disabled.

Applying a License Key

License keys can be purchased for expanding library capacity, control path failover,
and data path failover.
License keys are absolute values that can only increase a licensed feature. For
example, if a license key specified a slot count of 92 slots and later a different
license key was installed that specified 46 slots, the total licensed slot count would
still be 92 slots. It is possible to license more slots than are physically available in
the library at the time. If an Expansion Module (EM) is added, the extra licensed
slots become available.
A Capacity Expansion license key (Feature Code 1640) can be applied to the library
during the initial configuration or at any time in the future. If additional features
are purchased (Control Path Failover and/or Data Path Failover), the new license
key replaces the current license key. The new license key includes all previously
licensed features along with the newly licensed features.
A Path Failover license key (Feature Code 1682) supplies one or both licenses for
Control Path Failover and/or Data Path Failover. For more information, refer to
"Using Multiple Control Paths for Control Path Failover" on page 2-3 and "Using
Multiple Data Paths for Data Path Failover" on page 2-3.
Note: The license key is made up of 5 alphanumeric characters.

Cleaning Slots Configuration

Zero to four (0 to 4) cleaning slots can be configured in your library. These slots
are taken from the unassigned available storage slots. Cleaning cartridges in these
slots are used by the library's Auto Clean function when the drives request
cleaning.
Host-based cleaning will not use these slots. Host-based cleaning will import
cleaning cartridges (CLNxxx) as data cartridges and assign them to a particular
logical library.
5-2
TS3310 Tape Library Setup and Operator Guide
network settings.
name can be up to a maximum of twelve characters long.
Setting the library to enable triggers via DHCP to automatically configure the
library network settings. "Enable" makes the IP Address, Subnet Mask, and
Default Gateway text boxes unavailable. "Disable" makes the IP Address,
Subnet Mask, and Default Gateway text boxes available for you to manually
set the library network settings.
DHCP is disabled.
the Ethernet network. This text box is available only if DHCP is disabled.