IBM System Storage TS3310 Setup And Operator Manual page 279

Figure 12-17. Library Control Blade (LCB)
4. Reconnect the Ethernet cable ( 2 in Figure 12-17) by pinching the tab and
5. Perform "Returning a Library or Library Module to Normal Operations after
Removing the Compact Flash Card
Important: When handling the Compact Flash Card, you must wear an ESD
2
1
3
4
1
Module communication
terminator
2
Ethernet cable (customer
supplied)
3
Latches
pushing the connector into the LCB.
Note: Six slots reside below the Ethernet cable. The four topmost slots are
reserved for future use. The two bottommost slots are designated as
Ethernet ( 5 in Figure 12-17) and serial ( 6 in Figure 12-17) ports, and
are reserved for use by IBM Service Personnel.
Repairs" on page 12-2.
anti-static wrist strap, or touch the library frame to discharge any
static electricity in your body. Do not handle the Compact Flash Card
without taking appropriate ESD precautions.
Selections made during library configuration reside on the Compact
Flash Card. Using the Appendix D, "Library Configuration Form," on
page D-1, record all current library settings before removing the card.
5
6
4
Module-to-module communication cable
5
Ethernet port (for IBM service personnel use)
6
Serial port (for IBM service personnel use)
Chapter 12. Add, Remove, and Replace Procedures
12-21