IBM System Storage TS3310 Setup And Operator Manual page 274

Removing a Drive Sled
Important: If removing more than one drive sled at a time, record the locations of
1. Vary all drives offline from the host.
Figure 12-12. Drive sled (detail)
2. Disconnect the drive cable and place it on a flat surface in a secure location to
3. Loosen the two thumb screws (
4. Slide the drive out of the library module. Grasp the handle (
12-16
TS3310 Tape Library Setup and Operator Guide
each drive before they are removed. Ensure that the drives are
reinstalled in the correct location.
v From the Operator Panel, select Operations → Change Drive Mode.
v From the Web User Interface, select Manage Drives → Change State of
Drives.
1
avoid damaging the cable.
a. For a SCSI drive, loosen the two thumb screws that hold the SCSI cable and
terminator in place by turning them counterclockwise. Disconnect the cable
and terminator from the drive being removed.
b. For a Fibre Channel drive, unplug the fibre cable.
by turning them counterclockwise.
and slowly pull the drive toward you, while supporting the drive sled from
underneath.
2
4
2
in Figure 12-12) that hold the drive in place
5
3
5
in Figure 12-12)