Cabling Of A 14U Library Containing - IBM System Storage TS3310 Setup And Operator Manual

3
2
Figure 4-24. Cabling of a 14U library containing multiple SCSI drives
| | |
| |
|
| | | |
|
| | | |
|
| | | |
|
| | | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
4
1
1
Module communication
terminator
2
Module-to-module
communication cable
3
Ethernet cable (customer
supplied)
4
Module communication
terminator
5
SCSI terminators
1. Install a module communication terminator in the upper receptacle of the
upper module of your library ( 4 in Figure 4-24).
2. Install one end of the module-to-module communication cable ( 2 in
Figure 4-24) in the lower receptacle of the upper module of your library, then
install the other end in the upper receptacle of the lower module of your
library.
3. Install a module communication terminator in the lower receptacle of the lower
module of your library ( 1 in Figure 4-24).
4. Install one end of the customer-supplied Ethernet cable ( 3 in Figure 4-24) in
the Library Control Blade Ethernet port, then connect the other end of the cable
to your network.
5. Installation of the SCSI cable(s) and terminator(s) depends upon how many
drives are in your library. For maximum SCSI drive performance:
v For each SCSI drive, install a SCSI terminator ( 5 in Figure 4-24) in the
upper receptacle of each SCSI drive in your library.
5
9
6
SCSI drive-to-host cable
7
Power cord (upper module)
8
Power cord (lower module)
9
SCSI drive-to-host cable
Chapter 4. Installing a New Standalone Library on a Desktop
7
6
8
4-23