Control Module Rear Thumb Screws - IBM System Storage TS3310 Setup And Operator Manual

Figure 12-7. Control module rear thumb screws
10. Tighten the rear thumb screws (
11. If your library is installed in a rack, reinstall the rack ears on the front of the
7. Adjust the control module's position on top of the expansion module until the
control module alignment pin drops into the alignment pin receptacle (
Figure 12-6 on page 12-8) in the lower expansion module.
8. Tighten the front thumb screw (
front of the control module to the lower expansion module (
on page 12-8).
9. Open the I/O Station door and tighten the other front thumb screw.
module to the lower expansion module.
control module to secure it to the rack (see "Replacing the Rack Ears" on page
12-12).
2
in Figure 12-4 on page 12-7) to secure the
1
1
in Figure 12-7) that secure the control
Chapter 12. Add, Remove, and Replace Procedures
1
in
2
in Figure 12-6
12-9