Gear Racks And Gear Rack Locking - IBM System Storage TS3310 Setup And Operator Manual

Figure 12-8. Gear racks and gear rack locking mechanism
12. Engage the rear (
13. Gently push the Picker assembly up high enough to release the Picker locking
14. Release the Picker assembly and allow it to slowly drop to the bottom of the
15. Reinstall all control module components removed for weight reduction.
12-10
TS3310 Tape Library Setup and Operator Guide
1
3
1
the control module. While pinching the gear rack locking mechanism (
Figure 12-8), push the gear rack down until it locks in place and no gaps
appear between the front and rear gear racks in the control module and
expansion module.
mechanism (see "Removing a Control Module from a Standalone or
Rack-mounted Library (14U or larger)" on page 12-3).
library.
a. Drive sleds (see "Adding/Removing/Replacing a Drive Sled" on page
12-15)
b. Power supplies (see "Removing/Replacing a Power Supply (Primary and
Redundant)" on page 12-24)
2
in Figure 12-8) and front (
3
in Figure 12-8) gear racks in
2
in