Powering On The Library - IBM System Storage TS3310 Setup And Operator Manual

|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|

Powering ON the Library

|
|
|
|
|
|
|
|
|
|
|
|
|
|
4-26
TS3310 Tape Library Setup and Operator Guide
2. Install one end of one of the module-to-module communication cable in the
lower receptacle of the upper module of your library, then install the other end
in the upper receptacle of the middle module of your library ( 2 in Figure 4-25
on page 4-25).
3. Install one end of the other module-to-module communication cable in the
lower receptacle of the middle module of your library, then install the other
end in the upper receptacle of the bottom module of your library ( 2 in
Figure 4-25 on page 4-25).
4. Install a module communication terminator in the lower receptacle of the
bottom module of your library ( 1 in Figure 4-25 on page 4-25).
5. Install one end of the customer-supplied Ethernet cable in the Library Control
Blade Ethernet port, then connect the other end of the cable to your network
( 3 in Figure 4-25 on page 4-25).
6. For each drive, install one end of the drive host fibre cable in a drive in the
library, then connect the other end of the cable to your network ( 10 in
Figure 4-25 on page 4-25). Repeat this for every drive in your library.
7. Connect one end of the power cord in the receptacle of a power supply in your
library, then connect the other end of the cord to your power source. Repeat
this for every power supply in your library ( 6 , 7 , and 9 in Figure 4-25 on
page 4-25).
8. Continue with "Powering ON the Library."
1. Turn the switch on each power supply ( 4 in Figure 4-22 on page 4-21) to the
ON (|) position.
2. Push the power button on the front panel of the library. A green LED to the left
of the power button indicates that the power is ON.
3. Wait for the library to initialize. This will take approximately 10 minutes.
Note: If the operator panel does not initialize, check all cable connections, and
ensure that all doors are tightly closed and all power supply switches are
in the ON position. Then, repeat steps 1 and 2. If the panel still does not
initialize, see "Diagnosing a Problem" on page 10-2.
4. When initialization is complete, configure the library. Read the information in
Chapter 5, "Configuration Planning," on page 5-1 and Chapter 6, "User
Interfaces," on page 6-1 before proceeding to Chapter 7, "Configuring the
Library," on page 7-1.