Installing Additional Modules In Your Library; Configuration; Picker Assembly Lock Mechanism - IBM System Storage TS3310 Setup And Operator Manual

|
|
|
|
|
Installing Additional Modules in Your Library Configuration
|
|
|
|
|
|
|
Figure 4-14. Picker assembly lock mechanism
|
|
|
|
|
|
4-14
TS3310 Tape Library Setup and Operator Guide
4. Ensure that the front and rear gear racks of both the control module and the
expansion module are locked in the upper position (see 2 in Figure 3-19 on
page 3-21).
5. Install the top cover, using the T10 Torx screws.
Once you have the bottom module installed, add additional modules to your
library.
1. If you are installing a 5U control module, ensure that the picker assembly lock
mechanism ( 1 in "Installing Additional Modules in Your Library
Configuration") is engaged as shown.
1
2. IMPORTANT: Ensure that the front and rear gear racks are locked in the
upper position (see 2 in Figure 3-19 on page 3-21).
3. Ensure that the module-to-module alignment pin ( 1 in Figure 4-15 on page
4-15) is in the raised position. If necessary, raise the pin and rotate it half a
turn to lock it in the raised position.