Transferring The Bottom Cover From The Control Module To An Expansion Module; Picker Locking Mechanism - IBM System Storage TS3310 Setup And Operator Manual

|
|
|
Transferring the Bottom Cover from the Control Module to an
Expansion Module
|
|
|
|
|
|
Figure 3-6. Picker locking mechanism
3-8
TS3310 Tape Library Setup and Operator Guide
be on the top. Refer to "Transferring the Top Cover from the Control Module to
an Expansion Module" on page 3-11. If the control module is on the top of
your library, you will not need to move the top cover.
Each library comes with a bottom cover that is shipped with the control module. If
you are installing an expansion module as the first or bottom module in a library,
you must move the bottom cover from the control module to the bottom of the
lower-most expansion module.
1. Engage the picker assembly lock mechanism ( 1 in Figure 3-6). You may need
to lift the picker assembly to fully engage the lock mechanism.
2. Turn the 5U control module on its side and remove the 5 - T10 Torx bottom
cover screws ( 1 in Figure 3-7 on page 3-9).
Important: DO NOT loosen or remove the screw holding the home sensor ( 2
in Figure 3-7 on page 3-9). This screw has the same T10 Torx head
as the cover screws, but it is longer and has a coarse thread for
screwing into the plastic home sensor.
1