Table of Contents
Advertisement
Chapter 6. Installing the Library
"Choosing a Location" on page 6-1
"Verifying the Shipment" on page 6-2
"Removing Components to Reduce Library Weight" on page 6-2
"Removing and Storing the Shipping Pin" on page 6-8
"Attaching Foot Pads for Installing on a Desktop" on page 6-10
"Installing the Library in a Rack" on page 6-11
"Adding a Drive Canister Shipped with Library" on page 6-18
"Adding a Drive Canister from Another Library (Feature Code 4685)" on page 6-19
"Installing Library Components Removed for Weight Reduction" on page 6-19
"Connecting the Power Cords" on page 6-20
"Verifying Library and Drive Operation" on page 6-20
"Connecting the Host Interface Cable and Network Cable" on page 6-21
"Configuring the Library" on page 6-22
To install a desktop or rack-mounted TS3400 Tape Library, perform the procedures in
this chapter in the order they are presented.
Choosing a Location
Choose a location that meets the following criteria:
Table 6-1. Location criteria
Criteria
Room temperature
Voltage
Frequency
Relative humidity
Air quality
Clearance
Rack requirements
© Copyright IBM Corp. 2008
4
Definition
16 to 32 °C (60 to 90 °F)
100 to 240 Vac.
Note that the power switch is located on the rear of the library and
must be easily accessible at all times.
50 to 60 Hz
20 to 80% non-condensing
The library should be placed in an area with minimal sources of
particulate contamination. Avoid areas near frequently used doors and
walkways, stacks of supplies that collect dust, printers, and
smoke-filled rooms. Excessive dust and debris can damage tapes and
tape drives.
• Back: Minimum of 15 cm (6 in.)
• Front: Minimum of 30 cm (12 in.)
• Sides: Minimum of 5 cm (2 in.)
Standard EIA 19-inch rack: 5U space
6-1
Advertisement
Table of Contents
