Installing The Library In A Rack - IBM TS2900 Manual

12. Remove the flat-head screws 6 on each side to remove the left 5 and right 3 rails from the chassis
Figure 5. Removing side rails from the library chassis

Installing the library in a rack

For details on the rack mount kit components, see
1. Determine the location in your rack for your library and mark with a pencil. For details on rack mount locations, see
2. Attach the left 3 and right 4 front brackets to the front of the library chassis with 2 flat-head screws 8 on each side
each side.
Figure 6. Attaching the front brackets to the library chassis
3. Attach the left 1 and right 2 rear brackets to the left 5 and right 6 front rails with 2 round-head screws 10 on each side
Note: Run the hook-and-loop fastener strap through the slot on the right rear bracket and attach it back upon itself.
Figure 7. Attaching the rear brackets to the rails
4. Slide in the rear rails 7 from back to front to create the rail assemblies. Ensure that the screw holes face outwards
Figure 8. Attaching the rear brackets to the rails
Installing in a rack.
(Figure 5)
Installing in a rack.
(Figure 6). Use the bottom two screw holes on
(Figure 7).
(Figure 8).
TS2900 Tape Autoloader 71