Lenovo System x3850 X6 Installation And Service Manual page 341

p. Locate the IBM server component serial number prefixes in the <serial>_Node1_
component.txt file. There are multiple component serial number prefixes in the
following format:
VPD.CompVPD_PrefixSerialNumber.# <prefix_s/n>
where:
• # is the component numeric identifier:
2 for the 8–socket midplane
3 for the front I/O panel assembly
4 for LCD display panel
Note: A serial number for the front I/O panel assembly (3) is not required and
might not be listed.
• <prefix_s/n> is a 6–character component serial number prefix
Notes:
• The Lenovo server component serial numbers remain unchanged: they are the
same serial numbers that were used in the IBM server.
• The serial number prefix is the six characters of the 11S barcode that follow the
first 10 characters of the 11S barcode (the six characters preceding the
component serial number portion of the 11S barcode). In the following example,
the serial number prefix is shown in bold:
11S12X4567YJ1105A34567
q. Add a command line to the batch file for each Lenovo server component serial
number prefix, following the form:
asu64 set VPD.CompVPD_PrefixSerialNumber.# <prefix_s/n>--host <IMM_IP> --user
<IMM_userid> --password <IMM_password>
where:
• # is the component numeric identifier:
2 for the 8–socket midplane
3 for the front I/O panel assembly
4 for LCD display panel
Note: A serial number for the front I/O panel assembly (3) is not required.
• <prefix_s/n> is a 6–character component serial number prefix (the Lenovo
server and the IBM server use the same component serial number prefixes)
• <IMM_IP> is the IMM IP address
• <IMM_userid> is the IMM user name
• <IMM_password> is the IMM password
Note: To view an example VPD batch file, see "IBM to Lenovo server upgrade batch
file examples" on page 336.
3. Save and close the file.
– To create a VPD batch file for node 2 of a Lenovo System x3950 X6 8-socket system:
1. Open a new <serial>_Node2_system.bat file (where <serial> is the serial number of the
standard I/O book in node 2, allowing each batch file to be identified). This file will be
edited to create a VPD update batch file for node 2.
.
Chapter 6 Removing and replacing components
327