Lenovo System x3850 X6 Installation And Service Manual page 294

Step 11. Update the front operator panel assembly part number and FRU part number in the customer
records, service offering support information and component Vital Product Data (VPD) using the
Advanced Settings Utility (ASU) program. For more information about using ASU and additional
command options, see "Advanced Settings Utility program" on page 140.
a. Update component part number in customer records and service offering support
information
The component part number is the first seven characters following the "11S" of the 11S
barcode. In the following example, the component part number is shown in bold:
11S12X4567YJ1105A34567
b. Update component part number VPD
Use the following ASU command to update the component VPD:
asu64 set VPD.CompVPD_PartNumber.3 "<p/n>[sp][sp][sp][sp][sp]"
where:
<p/n> is the 7–character component part number followed by five padding spaces.
c. Update FRU part number in customer records and service offering support information
The FRU part number is the first seven characters following the "FRU:" of the FRU barcode. In
the following example, the FRU part number is shown in bold:
FRU:12X4567
d. Update FRU part number VPD
Use the following ASU command to update the FRU part number VPD:
asu64 set VPD.CompVPD_FRUNumber.3 "<fru_number>[sp][sp][sp][sp][sp]"
where:
<fru_number> is the 7–character FRU part number above followed by five padding spaces.
Step 12. Restart the IMM2; then, restart the server.
Removing the LCD system information display panel
Use this information for instructions on how to remove the LCD system information display panel.
To remove the LCD system information display panel, complete the following steps.
Step 1. Before you begin, read "Safety" on page v and "Installation guidelines" on page 44 .
Step 2. Turn off the server (see "Turning off the server" on page 40) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the
device.
Step 3. Remove the storage book from the server (see "Removing the storage book" on page 273).
Step 4. Disconnect the front operator panel cable from the storage book board.
Step 5. Slide the blue release latch on top of the front operator panel back to remove the operator panel.
280
System x3850 X6 and x3950 X6 Installation and Service Guide