When you install RAID adapters that come with flash power modules in the standard I/O book , install the
flash power modules in the slots inside the standard I/O book air baffle to prevent them from overheating. To
install the flash power modules in the air baffle, complete the following steps:
Step 1.
Place the new flash power module into the flash power module slot in the air baffle.
Flash power
module
Air baffle
Flash power
module slots
Step 2.
If you install the flash power modules in the two slots on the left side (facing the front of the
standard I/O book) of the air baffle, route the cables through the clips and the holes on the side of
the air baffle, as shown in the following illustration. When you install a flash power module in the
slot on the right side of the air baffle, route the cable through the hole under the flash power module
slot.
Step 3.
Connect the flash power module cable to the adapter.
Step 4.
Close the air baffle cover. Rotate the cover down and press it until it is locked in place.
Step 5.
Reinstall the standard I/O book (see "Replacing the standard I/O book" on page 227).
Standard I/O book
.
Chapter 6
Removing and replacing components
267