Lenovo System x3850 X6 Installation And Service Manual page 286

Removing the front I/O panel (USB/video) assembly
Use this information for instructions on how to remove the front I/O panel.
To remove the front I/O panel, complete the following steps.
Step 1. Before you begin, read "Safety" on page v and "Installation guidelines" on page 44 .
Step 2. Turn off the server (see "Turning off the server" on page 40) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the
device.
Step 3. Remove the storage book from the server (see "Removing the storage book" on page 273).
Step 4. Disconnect the USB/video cables from the storage book board.
Step 5. Press the release latch on the right side of the storage book and place two fingers in the finger
holes and carefully slide the front I/O panel forward toward the front of the storage bookand
remove it.
Release latch
Storage
book
Front I/O
panel
Step 6. If you are instructed to return the front I/O panel assembly, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Replacing the front I/O panel (USB/video) assembly
Use this information for instructions on how to replace the front I/O panel.
To install the front I/O panel, complete the following steps.
Step 1. Route USB/video cables through the cable slot on the air baffle and hold the cables in place.
Step 2. From the front of the storage book, align the assembly with the slot on the storage book and slide
the front I/O panel into the storage book until it is seated firmly.
272
System x3850 X6 and x3950 X6 Installation and Service Guide
Finger holes