Lenovo System x3850 X6 Installation And Service Manual page 328

<IMM userid> is the IMM user name
<IMM password> is the IMM password
<serial> is the serial number of the standard I/O book (allows each data file to be
identified)
b. To save the system component VPD information for node 1 into a file, run the ASU
command:
asu64 show VPD --host <IMM IP> --user <IMM userid> --password <IMM password> >
<serial>_Node1_component.txt
where:
<IMM IP> is the IMM IP address
<IMM userid> is the IMM user name
<IMM password> is the IMM password
<serial> is the serial number of the standard I/O book (allows each data file to be
identified)
– To save the system VPD information for node 2 of an IBM System x3950 X6 8–socket system,
complete the following steps:
a. To save the system VPD information for node 2 into a file, run the ASU command:
asu64 show SYSTEM_PROD_DATA --host <IMM IP> --user <IMM userid> --password <IMM
password> > <serial>_Node2_system.txt
where:
<IMM IP> is the IMM IP address
<IMM userid> is the IMM user name
<IMM password> is the IMM password
<serial> is the serial number of the standard I/O book (allows each data file to be
identified)
b. To save the system component VPD information for node 2 into a file, run the ASU
command:
asu64 show VPD --host <IMM IP> --user <IMM userid> --password <IMM password> >
<serial>_Node2_component.txt
where:
<IMM IP> is the IMM IP address
<IMM userid> is the IMM user name
<IMM password> is the IMM password
<serial> is the serial number of the standard I/O book (allows each data file to be
identified)
6. Make sure that the server is operating correctly and that there are no errors messages (see "Error
messages" on page 168). Correct any problems that are indicated, unless they relate to components or
firmware being replaced as part of the ITL upgrade.
Perform the ITL upgrade
Attention: Installation of the ITL kit must be performed by a Lenovo-approved service technician.
To upgrade an IBM server to a Lenovo server, the service technician must complete the following steps:
Step 1. Mark and disconnect all cables from the IBM standard I/O books.
314
System x3850 X6 and x3950 X6 Installation and Service Guide