Table of Contents
Advertisement
7.
Swing the fuel tank in to the chassis and secure
the fuel tank; refer to
the Left Side (page
Accessing the Engine from
49).
Controls System
Maintenance
Adjusting the PTO Clutch
Gap
Service Interval: Every 200 hours
1.
Park the machine on a level surface.
2.
Disengage the PTO, lower the mower deck, and
engage the parking brake.
3.
Raise and secure the hopper; refer to
the Hopper (page 30)
in the Raised Position (page
4.
Shut off the engine and remove the key.
5.
Open the engine-access cover; refer to
Accessing the Engine from the Engine-Access
Cover (page
49).
6.
Adjust the air gap so that a 0.4 mm (0.015 inch)
feeler gauge slides in between the clutch lining
and friction plate with light pressure
Note:
You can decrease the gap by turning
the adjusting nut clockwise
maximum service gap is 0.7 mm (0.030 inch).
Adjust all 3 air gaps.
1. Clutch
2. 0.4 mm (0.015 inch) air
gap (3)
3. Adjusting nut (3)
7.
After you have set all 3 gaps, check the 3 gaps
again.
Note:
Adjusting 1 gap can alter the other gaps.
67
Raising
and
Securing the Hopper
42).
(Figure
(Figure
95). The
Figure 95
4. Electrical connector
5. PTO belt
95).
g001252
Advertisement
Table of Contents
