Huawei Tecal RH5485 Problem Determination And Service Manual page 47

Tecal RH5485 Server
Problem Determination and Service Guide
3058004
3108007
3138002
3808000
3808002
3808003
3808004
Issue 02 (2011-05-25)
Three boot failures
System configuration
restored to default settings
Boot configuration error
Error updating
configuration to IMM
Error updating
configuration to IMM
Error retrieving
configuration from IMM
IMM system event log full
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
time, in the order shown, restarting the server
each time:
a. Battery
b. Failing device (if the device is a FRU, it must
be replaced by a trained service technician
only)
c. (Trained service technician only) I/O-board
shuttle
1. Undo any recent system changes, such as
new settings or newly installed devices.
2. Make sure that the server is attached to a
reliable power source.
3. Remove all hardware that is not listed on the
ServerProven Web site.
4. Make sure that the operating system is not
corrupted.
5. Run the Setup utility, save the configuration,
and then restart the server.
Information only. This is message is usually
associated with the CMOS battery clear event.
1. Remove any recent configuration changes
that
you made in the Setup utility.
2. Run the Setup utility, select Load Default
Settings, and save the settings.
system
system 1. Remove power from the server, and then
reconnect the server to power and restart it.
2. Run the Setup utility and select Save
Settings.
3. Update the firmware.
system 1. Remove power from the server, and then
reconnect the server to power and restart it.
2. Run the Setup utility and select Save
Settings.
3. Update the IMM firmware.

When out-of-band, use the IMM Web
interface or IPMItool to clear the logs
3 Diagnostics
3-29