Huawei Tecal RH5485 Problem Determination And Service Manual page 155

Hide thumbs Also See for Tecal RH5485:

Table of Contents

Tecal RH5485 Server

Problem Determination and Service Guide

Step 1 Read the safety information and "Installation guidelines".

Step 2 If only one power supply is installed, turn off the server.

Step 3 Disconnect the power cord from the connector on the back of the power supply.

Step 4 Slide the orange release latch on the handle to the right and lift the handle up to the open

position.

Step 5 Pull the power supply out of the bay.

Step 6 If you are instructed to return the hot-swap power supply, follow all packaging instructions,

and use any packaging materials for shipping that are supplied to you.

----End

Replacing the hot-swap power supply

To install the replacement hot-swap power supply, complete the following steps:

Step 1 Touch the static-protective package that contains the power supply to any unpainted surface

on the outside of the server; then, remove it from the package.

Step 2 Press the orange release latch on the handle to the right and pull the handle up to the open

position if it is not already in the open position.

Step 3 Push the power supply into the bay, slide the latch to the right, and push the handle down to

lock it.

Step 4 Connect one end of the power cord for the new power supply into the ac inlet on the back of

the power supply, and connect the other end of the power cord into a properly grounded

electrical outlet.

Step 5 Route the cable through the retention hook on the back of the power supply.

Issue 02 (2011-05-25)

NOTE

If your server has only one power supply, you must turn off the server before you remove the power

supply.

Huawei Proprietary and Confidential

5 Removing and replacing components

5-25

Table of Contents