Table of Contents
Advertisement
Tecal RH5485 Server
Problem Determination and Service Guide
Step 2 Carefully grasp the adapter by its top edge or upper corners, and align it with the connector
on the I/O board.
Step 3 Press the adapter firmly into the adapter connector.
Step 4 Rotate the latch closed and push it down on the blue latch until it clicks into place, securing
the adapter.
Step 5 Connect any required cables to the adapter.
Step 6 Install the top cover (see "Replacing the top cover").
Step 7 Connect the cables and power cords (see "Connecting the cables" for cabling instructions).
Step 8 Turn on all attached devices and the server.
----End
Removing the battery
To remove the battery, complete the following steps:
Step 1 Read the safety information and "Installation guidelines".
Step 2 Turn off the server and peripheral devices, and disconnect the power cords and all external
cables as necessary to replace the device.
Step 3 Remove the top cover (see "Removing the top cover").
Step 4 Locate the battery (see "I/O-board connectors").
Step 5 If any PCI adapters are blocking access to the battery, remove them (see "Removing an
adapter").
Step 6 Remove the battery:
1.
2.
Step 7 Dispose of the battery as required by local ordinances or regulations.
----End
Issue 02 (2011-05-25)
Use one finger to push the battery horizontally out of its housing.
Lift the battery from the socket.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Removing and replacing components
5-15
Advertisement
Table of Contents
