Using The Embedded Hypervisor - Huawei Tecal RH5485 Problem Determination And Service Manual

Tecal RH5485 Server
Problem Determination and Service Guide
----End

6.2.9 Using the embedded hypervisor

The VMware ESXi embedded hypervisor software is available on the HUAWEI USB flash
device with embedded hypervisor. The USB flash device can be installed in either of the I/O
board internal USB ports (see the following illustration). Hypervisor is virtualization software
that enables multiple operating systems to run on a host system at the same time. The USB
flash device is required to activate the hypervisor functions.
To start using the embedded hypervisor functions, you must add the USB flash device to the
startup sequence in the Setup utility.
To add the USB flash device to the startup sequence, complete the following steps:
Step 1 Turn on the server.
Step 2 When the prompt <F1> Setup is displayed, press F1.
Step 3 From the Setup utility main menu, select Boot Manager.
Step 4 Select Add Boot Option; then, select USB Storage. Press Enter, and then select Esc.
Issue 02 (2011-05-25)
NOTE
Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button
becomes active.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Configuration information and instructions
6-13