Table of Contents
Advertisement
Tecal RH5485 Server
Problem Determination and Service Guide
Step 1 Read the safety information and "Installation guidelines".
Step 2 Turn off the server and peripheral devices, and disconnect the power cords and all external
cables as necessary to replace the device.
Step 3 Remove the top cover (see "Removing the top cover").
Step 4 Remove the top cover bracket (see "Removing the top-cover bracket").
Step 5 Remove any installed adapters (see "Removing an adapter" 7).
Step 6 Remove the power supplies or power-supply fillers from the rear of the server (see
"Removing a hot-swap power supply").
Step 7 Pull out the blue release pin to unlatch the shuttle, and then rotate the shuttle handle up.
Step 8 Disconnect the front USB cable and the DVD signal cable from the connectors on the shuttle.
Step 9 Pull up on the handle to remove the I/O-board shuttle assembly from the server and place it
on a flat surface.
Step 10 If you are instructed to return the I/O-board shuttle, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
----End
Replacing the I/O-board shuttle
To install the replacement rear I/O-board shuttle, complete the following steps:
Step 1 Align the I/O-board shuttle over the server so that the pins on the side of the chassis can slide
into the slots on the side of the server.
Issue 02 (2011-05-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Removing and replacing components
5-41
Advertisement
Table of Contents
